Difficulty

Easy

Steps

8

Time Required

                          5 minutes

Sections

3

  • Battery
  • 3 steps
  • Back Panel
  • 2 steps
  • Memory Module
  • 3 steps

Flags

0

  • BackHP Envy 17-J013CL

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Battery
  • Lay the laptop with the battery facing towards you.
  • Remember to disconnect the AC cable and other power sources from the device before replacing/repairing parts.

Lay the laptop with the battery facing towards you.

Remember to disconnect the AC cable and other power sources from the device before replacing/repairing parts.

1024

Step 2

  • Grab hold of the small battery slider and apply pressure to the right.
  • The laptop itself will push the battery out for you once the switch slides all the way to the right.

Grab hold of the small battery slider and apply pressure to the right.

The laptop itself will push the battery out for you once the switch slides all the way to the right.

Step 3

  • Pull the battery out and let go of the battery slider.

Pull the battery out and let go of the battery slider.

Step 4

              Back Panel
  • Use a PH1-screwdriver to loosen the 7mm screw. The screw will not fully come out as it is held by a washer underneath but will come out enough to open it.

Use a PH1-screwdriver to loosen the 7mm screw. The screw will not fully come out as it is held by a washer underneath but will come out enough to open it.

Step 5

  • Gently pull the back panel off starting from the battery side towards the back.
  • Pull it back as it snaps out of the holding sockets.
  • It is preferred to use both hands when pulling the back panel off to prevent bending it out of shape.

Gently pull the back panel off starting from the battery side towards the back.

Pull it back as it snaps out of the holding sockets.

It is preferred to use both hands when pulling the back panel off to prevent bending it out of shape.

Step 6

              Memory Module
  • Locate the memory stick inside.

Locate the memory stick inside.

Step 7

  • On both sides of the module, place a thumb on each of the metallic holding pins.
  • Gently pull on the pins to release the spring holding in the module.

On both sides of the module, place a thumb on each of the metallic holding pins.

Gently pull on the pins to release the spring holding in the module.

Step 8

  • Gently slide the module out of the memory slot.
  • Pay in mind of the module’s orientation as it will only go in one way with a little gap in the module to identify orientation.

Gently slide the module out of the memory slot.

Pay in mind of the module’s orientation as it will only go in one way with a little gap in the module to identify orientation.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 


                    Matt McBride

Member since: 02/02/2017

827 Reputation

                                      6 Guides authored                  



                       Badges:
                       10







                                                        +7 more badges

Team

                       USF Tampa, Team 16-6, Blackwell Spring 2017                        

                                                  Member of USF Tampa, Team 16-6, Blackwell Spring 2017 



                    USFT-BLACKWELL-S17S16G6                     


                                            3 Members                     


                                            6 Guides authored