Hp Envy 5530 Gear For Scanner Arm Replacement Repair Guide

Difficulty

Moderate

Steps

8

Time Required

                          20 minutes            

Sections

1

• Gear for Scanner Arm Actuator
• 8 steps

Flags

0

• BackHP ENVY 5530

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Gear for Scanner Arm Actuator               

• Unscrew and remove the center 13mm T10 Torx Security screw using the iFixit screwdriver
• Unscrew and remove the top right 13mm T10 Torx Security screw using the iFixit screwdriver
• Unscrew and remove the bottom left 13mm T10 Torx Security screw using the iFixit screwdriver

Unscrew and remove the center 13mm T10 Torx Security screw using the iFixit screwdriver

Unscrew and remove the top right 13mm T10 Torx Security screw using the iFixit screwdriver

Unscrew and remove the bottom left 13mm T10 Torx Security screw using the iFixit screwdriver

1024

Step 2

• Unscrew and remove the bottom 13mm TR10 Torx Security screws using the iFixit screwdriver

Unscrew and remove the bottom 13mm TR10 Torx Security screws using the iFixit screwdriver

Step 3

• Unscrew and remove the top right13mm TR10 Torx Security screws using the iFixit screwdriver

Unscrew and remove the top right13mm TR10 Torx Security screws using the iFixit screwdriver

Step 4

• Unscrew and remove the upper 13mm TR10 Torx Security screw using the iFixit screwdriver

Unscrew and remove the upper 13mm TR10 Torx Security screw using the iFixit screwdriver

Step 5

• Remove the scanner lid and plate (top cover).
• Locate the Scanner Arm Actuator.

Remove the scanner lid and plate (top cover).

Locate the Scanner Arm Actuator.

Step 6

• Locate the Scanner Arm Accuator and remove.

Locate the Scanner Arm Accuator and remove.

Step 7

• Unscrew and remove the 13mm TR10 Torx Security screw in the center of the gear using the iFixit screwdriver

Unscrew and remove the 13mm TR10 Torx Security screw in the center of the gear using the iFixit screwdriver

Step 8

• Locate the white gear and remove.

Locate the white gear and remove.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.                                             

Author

                                      with 3 other contributors 

                    Elizabeth Surface                     

Member since: 08/26/2015

1,447 Reputation

                                      9 Guides authored                  



                       Badges:
                       16







                                                        +13 more badges                           

Team

                       USF Tampa, Team 4-6, Meier Fall 2015                        

                                                  Member of USF Tampa, Team 4-6, Meier Fall 2015 



                    USFT-MEIER-F15S4G6                     


                                            4 Members                     


                                            14 Guides authored                     

Ron - Nov 23, 2018

Reply

It is not possible to get to the bottom two screws out without tilting the scan bed/cover back more. To that, I had to disconnect the swing arm on the right side of the scanner bed/cover. After that, all worked smoothly. Thank you.