Difficulty
Moderate
Steps
9
Time Required
15 - 20 minutes
Sections
2
- Scanner Glass
- 8 steps
- Scanner Piece
- 1 step
Flags
0
BackHP Envy 5660
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Scanner Glass
- Open the cartridge access area.
Open the cartridge access area.
1024
Step 2
- Remove the three 11.5 mm screws with a T10 bit.
Remove the three 11.5 mm screws with a T10 bit.
Step 3
- Locate the cover hinge on the right side of the printer.
- Pull the hinge off of the scanner to allow the scanner to open to 90 degress.
Locate the cover hinge on the right side of the printer.
Pull the hinge off of the scanner to allow the scanner to open to 90 degress.
Step 4
- Remove the 12 mm screws on the left side of the printer with a T10 bit.
Remove the 12 mm screws on the left side of the printer with a T10 bit.
Step 5
- Remove the 11.5 mm screw with a T10 bit to release the spring-loaded hinge.
- Since this is a compression spring, the hinge will snap downwards as soon as it is loosened.
Remove the 11.5 mm screw with a T10 bit to release the spring-loaded hinge.
Since this is a compression spring, the hinge will snap downwards as soon as it is loosened.
Step 6
- Pull the plastic side cover off of the printer.
- You may need to lift the printer and push the cover downwards as it is latched onto the bottom of the printer.
- Plastic opening tools or a metal spudger may also be used.
Pull the plastic side cover off of the printer.
You may need to lift the printer and push the cover downwards as it is latched onto the bottom of the printer.
Plastic opening tools or a metal spudger may also be used.
Step 7
- Remove the five 11.5 mm screws located at the bottom of the scanner.
- Steps 3-6 were intended to create easier access to these screws. However, they will still be difficult to reach.
- The top of the scanner will now easily pull off.
Remove the five 11.5 mm screws located at the bottom of the scanner.
Steps 3-6 were intended to create easier access to these screws. However, they will still be difficult to reach.
The top of the scanner will now easily pull off.
Step 8
- Pry the old scanning glass up with a metal spudger.
- There are adhesives under the scanning glass. Be careful not to break the glass while removing it.
Pry the old scanning glass up with a metal spudger.
There are adhesives under the scanning glass. Be careful not to break the glass while removing it.
Step 9
Scanner Piece
- The scanning piece is located in the bottom half of the scanner that was not separated from the printer.
- Lift the scanning piece and detach the ribbon cable by gently pulling on it.
The scanning piece is located in the bottom half of the scanner that was not separated from the printer.
Lift the scanning piece and detach the ribbon cable by gently pulling on it.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 2 other contributors
Ryan Steakley
Member since: 01/23/2018
781 Reputation
5 Guides authored
Badges:
9
+6 more badges
Team
Cal Poly, Team S1-G6, Livingston Winter 2018
Member of Cal Poly, Team S1-G6, Livingston Winter 2018
CPSU-LIVINGSTON-W18S1G6
4 Members
5 Guides authored
