Difficulty

Moderate

Steps

6

Time Required

                          6 - 10 minutes            

Sections

2

  • Battery
  • 2 steps
  • WLAN Card
  • 4 steps

Flags

0

  • BackHP Envy m6-1105dx

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Battery               
  • Turn the computer completely off.
  • Disconnect any devices you have on it.
  • Turn the computer upside down on a flat surface.

Turn the computer completely off.

Disconnect any devices you have on it.

Turn the computer upside down on a flat surface.

1024

Step 2

  • Push the battery release latch with one hand.
  • Grab the battery with the other hand.
  • Lift out on an angle.

Push the battery release latch with one hand.

Grab the battery with the other hand.

Lift out on an angle.

Step 3

              WLAN Card               
  • Release the screw in the center of the service cover.
  • Slide the battery release latch and pull cover towards you.
  • Lift cover off.

Release the screw in the center of the service cover.

Slide the battery release latch and pull cover towards you.

Lift cover off.

Step 4

  • Use a JIS #0 screwdriver to unscrew the small cover where the WLAN card is.
  • The screw does not come out all the way so unscrew it as far as you can then try to life the cover.

Use a JIS #0 screwdriver to unscrew the small cover where the WLAN card is.

The screw does not come out all the way so unscrew it as far as you can then try to life the cover.

Step 5

  • Use a plastic opening tool to gently disconnect the WLAN antenna cables.

Use a plastic opening tool to gently disconnect the WLAN antenna cables.

Step 6

  • Remove the two PM2.0×3.0 screws that secure the WLAN module to the base using the JIS #0 screwdriver.
  • Using two fingers, grab the sides of the WLAN card and slowly pull it out.

Remove the two PM2.0×3.0 screws that secure the WLAN module to the base using the JIS #0 screwdriver.

Using two fingers, grab the sides of the WLAN card and slowly pull it out.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors 

                    Ian Mwalago                     

Member since: 10/14/2018

303 Reputation

                                      2 Guides authored                  



                       Badges:
                       6







                                                        +3 more badges                           

Team

                       UMass Dartmouth, Team S1-G5, Valliere Fall 2018                        

                                                  Member of UMass Dartmouth, Team S1-G5, Valliere Fall 2018 



                    UMASSD-VALLIERE-F18S1G5                     


                                            5 Members                     


                                            4 Guides authored