Difficulty

Moderate

Steps

9

Time Required

                          10 minutes

Sections

3

  • Battery
  • 1 step
  • Hard Drive
  • 3 steps
  • Speaker
  • 5 steps

Flags

0

  • BackHP Envy m6-n010dx

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Battery
  • Find the battery removal slider.
  • Slide it across while simultaneously popping out and removing the device’s battery.

Find the battery removal slider.

Slide it across while simultaneously popping out and removing the device’s battery.

1024

Step 2

              Hard Drive
  • Remove the five marked screws found under the battery using a philips head screwdriver.

Remove the five marked screws found under the battery using a philips head screwdriver.

Step 3

  • Remove the small panel on the back by prying it off. This should reveal the hard drive.

Remove the small panel on the back by prying it off. This should reveal the hard drive.

Step 4

  • The hard drive is connected to the motherboard via this blue-tabbed cable, highlighted in red.
  • Gently pry off the cover to release the cable.
  • Slowly lift the hard drive out and away from the device.

The hard drive is connected to the motherboard via this blue-tabbed cable, highlighted in red.

Gently pry off the cover to release the cable.

Slowly lift the hard drive out and away from the device.

Step 5

              Speaker
  • Remove the marked screws.
  • Pry off the lower two grip pads.
  • You may need to use more force than feels necessary.
  • Remove the two additional screws underneath the lower grip pads.
  • Remove the large back panel to reveal the inner workings.
  • The back panel might be difficult to remove. Use a flat object to help pry it off, and don’t be afraid to use force.

Remove the marked screws.

Pry off the lower two grip pads.

You may need to use more force than feels necessary.

Remove the two additional screws underneath the lower grip pads.

Remove the large back panel to reveal the inner workings.

The back panel might be difficult to remove. Use a flat object to help pry it off, and don’t be afraid to use force.

Step 6

  • Locate the speaker.
  • Locate the tape on the speaker.
  • Peel back the tape, disconnecting it from the speaker.
  • When reassembling the speaker, make sure to use new electrical tape so it will stick.

Locate the speaker.

Locate the tape on the speaker.

Peel back the tape, disconnecting it from the speaker.

When reassembling the speaker, make sure to use new electrical tape so it will stick.

Step 7

  • Locate the connecting wire attached to the speaker.
  • Disconnect the wire.

Locate the connecting wire attached to the speaker.

Disconnect the wire.

Step 8

  • Use a screwdriver to unscrew the three screws on the speaker.

Use a screwdriver to unscrew the three screws on the speaker.

Step 9

  • Remove the speaker.

Remove the speaker.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 4 other contributors 


                    Justin Lee

Member since: 02/08/2018

144 Reputation

                                      1 Guide authored                  



                       Badges:
                       5







                                                        +2 more badges

Team

                       University of North Texas, Team S2-G1, Thomas Spring 2018                        

                                                  Member of University of North Texas, Team S2-G1, Thomas Spring 2018 



                    UNT-THOMAS-S18S2G1                     


                                            4 Members                     


                                            6 Guides authored