Difficulty

Moderate

Steps

13

Time Required

                          10 - 15 minutes

Sections

2

  • Back Panel
  • 10 steps
  • Audio Board
  • 3 steps

Flags

1

Better Introduction

Improve this guide by completing or revising its introduction.

  • BackHP Envy X2-15-C001Dx

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Back Panel
  • Place the laptop face down on a table.

Place the laptop face down on a table.

1024

Step 2

  • Lift up the back stand.

Lift up the back stand.

Step 3

  • Remove the five screws from the bottom of the back plate using a Phillips #1 screwdriver.

Remove the five screws from the bottom of the back plate using a Phillips #1 screwdriver.

Step 4

  • Remove four screws from the back stand hinges using a Phillips #1 screwdriver.

Remove four screws from the back stand hinges using a Phillips #1 screwdriver.

Step 5

  • Remove the hinges and the back stand from the laptop.

Remove the hinges and the back stand from the laptop.

Step 6

  • Use a spudger to remove the thin panel where the back stand was.

Use a spudger to remove the thin panel where the back stand was.

Step 7

  • Remove the screws from the back panel using a Phillips #1 screwdriver.

Remove the screws from the back panel using a Phillips #1 screwdriver.

Step 8

  • Remove two side screws using a Phillips #1 screwdriver.

Remove two side screws using a Phillips #1 screwdriver.

Step 9

  • Pry apart the base from the screen by going around the entire perimeter with an opening tool.

Pry apart the base from the screen by going around the entire perimeter with an opening tool.

Step 10

  • Remove the back panel from the laptop.

Remove the back panel from the laptop.

Step 11

              Audio Board
  • Remove the three 6 mm screws from the audio board using a Phillips #1 screwdriver.

Remove the three 6 mm screws from the audio board using a Phillips #1 screwdriver.

Step 12

  • Flip up the black retaining flap securing the audio board’s ribbon cable.
  • Slide the ribbon cable out of its connector on the audio board.

Flip up the black retaining flap securing the audio board’s ribbon cable.

Slide the ribbon cable out of its connector on the audio board.

Step 13

  • Remove the audio board from the laptop.

Remove the audio board from the laptop.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 1 other contributor 


                    Dylan Hathaway

Member since: 10/25/2021

680 Reputation

                                      5 Guides authored                  



                       Badges:
                       11







                                                        +8 more badges

Team

                       UMass Dartmouth, Team 2-6, Sinclaire Fall 2021                        

                                                  Member of UMass Dartmouth, Team 2-6, Sinclaire Fall 2021 



                    UMASSD-SINCLAIRE-F21S2G6                     


                                            3 Members                     


                                            6 Guides authored