Difficulty

Moderate

Steps

5

Time Required

                          8 - 15 minutes

Sections

2

  • Back Panel
  • 3 steps
  • Battery
  • 2 steps

Flags

0

  • BackHP Envy x360 m6-aq003dx

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Back Panel
  • Turn the laptop over and use the plastic opening tool to take off the rubber pads. You only need to take off the two pads at the top for this device.

Turn the laptop over and use the plastic opening tool to take off the rubber pads. You only need to take off the two pads at the top for this device.

1024

Step 2

  • Use the Torx T5 screwdriver to remove the six small screws.
  • Use the Phillips #0 screwdriver to remove the screws under the rubber pads in step 1.

Use the Torx T5 screwdriver to remove the six small screws.

Use the Phillips #0 screwdriver to remove the screws under the rubber pads in step 1.

Step 3

  • Go slowly around the edge with the opening tool. The noises you will hear are due to the small joints popping open. Continue this until you have made your way around the entire laptop.

Go slowly around the edge with the opening tool. The noises you will hear are due to the small joints popping open. Continue this until you have made your way around the entire laptop.

Step 4

              Battery
  • Remove the six 4mm screws around the battery using a Phillips #0 screwdriver.

Remove the six 4mm screws around the battery using a Phillips #0 screwdriver.

Step 5

  • Disconnect the white connector from the battery to the board. (It is recommended to use pliers to remove the cord to avoid touching the board).
  • Once the connector and screws are both removed, lift the battery up and remove it from the laptop.
  • The removal of the connector and the screws can be done in either order.

Disconnect the white connector from the battery to the board. (It is recommended to use pliers to remove the cord to avoid touching the board).

Once the connector and screws are both removed, lift the battery up and remove it from the laptop.

The removal of the connector and the screws can be done in either order.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      2 other people completed this guide.

Author

                                      with 3 other contributors 


                    Paris Williams

Member since: 09/25/2019

136 Reputation

                                      1 Guide authored                  



                       Badges:
                       6







                                                        +3 more badges

Team

                       Embry-Riddle Aeronautical University, Team S13-G3, Lamothe Fall 2019                        

                                                  Member of Embry-Riddle Aeronautical University, Team S13-G3, Lamothe Fall 2019 



                    ERAU-LAMOTHE-F19S13G3                     


                                            4 Members                     


                                            5 Guides authored