Hp Envy X360 M6 Aq103Dx Bottom Cover Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

                          5 minutes

Sections

Bottom Cover
4 steps

Flags

BackHP Envy x360 m6-aq103dx
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Bottom Cover

Flip the laptop over to expose the underside.
Remove the two grip pads with blue plastic opening tool by inserting the tool between the laptop and the pads and slowly lifting up.
The grip pads are tacky, remove slowly to avoid separating the adhesive.

Flip the laptop over to expose the underside.

Remove the two grip pads with blue plastic opening tool by inserting the tool between the laptop and the pads and slowly lifting up.

The grip pads are tacky, remove slowly to avoid separating the adhesive.

1024

Step 2

Remove the two 8 mm Phillips Head screws that were under the grip pads using a Phillip’s Head 1 Screwdriver.

Remove the two 8 mm Phillips Head screws that were under the grip pads using a Phillip’s Head 1 Screwdriver.

Step 3

Remove the six 5 mm Torx screws using a T5 Torx Screwdriver.

Remove the six 5 mm Torx screws using a T5 Torx Screwdriver.

Step 4

Use the nylon spudger to pop off the bottom cover by inserting it into the heat vent and twisting to the left or right.
You may hear a slight clicking or popping, but that is normal.

Use the nylon spudger to pop off the bottom cover by inserting it into the heat vent and twisting to the left or right.

You may hear a slight clicking or popping, but that is normal.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      7 other people completed this guide.

Author

                                      with 3 other contributors

                    Sarah Samora

Member since: 10/02/2017

750 Reputation

                                      3 Guides authored                  



                       Badges:
                       16







                                                        +13 more badges

Team

                       Cal Poly, Team S4-G3, Livingston Fall 2017                        

                                                  Member of Cal Poly, Team S4-G3, Livingston Fall 2017 



                    CPSU-LIVINGSTON-F17S4G3                     


                                            4 Members                     


                                            9 Guides authored

Joshua Bowman - Jan 7, 2018

what should I do if I don’t have a nylon spudger? Is it safe to use my fingers to pry it open? I know I need to be careful about static or else it could fry the comp.

[deleted] - May 29, 2018

It was really easy to open.

MrHarris73 - Sep 21, 2018

Glad I read this…didn’t know about the 2 screws under the grip pads. Once again the internet comes through.

imran abdulhameed - Apr 17, 2019

But where can i purchase the bottom cover

Introduction#

What you need#

#

#

#

#

#

#

Team#

#

Introduction

What you need

Team