Difficulty
Easy
Steps
7
Time Required
10 minutes
Sections
2
- Keyboard
- 4 steps
- Speakers
- 3 steps
Flags
0
BackHP Envy x360 m6-w103dx
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
If you suspect there are issues with the speakers, please refer to the troubleshooting guides here.
Wear the anti-static wrist strap and attach it to a metal surface to avoid damaging sensitive electrical components. Make sure the computer is unplugged and powered off before touching any internal parts.
The speakers aren’t hazardous components to handle.
What you need
Step 1
Keyboard
- Before you begin, be sure to power off your laptop.
- Using an opening pick, remove the 4 rubber feet and 4 screw covers.
Before you begin, be sure to power off your laptop.
Using an opening pick, remove the 4 rubber feet and 4 screw covers.
1024
Step 2
- Unscrew the twelve 6 mm screws from the bottom of the laptop using a Phillips #0 screwdriver.
Unscrew the twelve 6 mm screws from the bottom of the laptop using a Phillips #0 screwdriver.
Step 3
- Open the laptop carefully, with the keyboard face up.
- Pry around the outside of the keyboard with the plastic opening tool until the keyboard can be lifted slightly.
- When lifting the keyboard do not pull too hard. There are cables that must be disconnected before the keyboard can be removed.
Open the laptop carefully, with the keyboard face up.
Pry around the outside of the keyboard with the plastic opening tool until the keyboard can be lifted slightly.
When lifting the keyboard do not pull too hard. There are cables that must be disconnected before the keyboard can be removed.
Step 4
- Lift the keyboard until you can see the cables connected to the motherboard.
- Gently lift the tab on each ZIF connector that connects each cable to the motherboard using a spudger. Once each tab is flipped up, the corresponding ribbon cable will come out easily.
- Detach the keyboard.
Lift the keyboard until you can see the cables connected to the motherboard.
Gently lift the tab on each ZIF connector that connects each cable to the motherboard using a spudger. Once each tab is flipped up, the corresponding ribbon cable will come out easily.
Detach the keyboard.
Step 5
Speakers
- Disconnect the connector on the left speaker by gently pulling on each side of the connector.
- Do not pull directly on the wires.
Disconnect the connector on the left speaker by gently pulling on each side of the connector.
Do not pull directly on the wires.
Step 6
- Unscrew the three 6mm screws using a #00 Phillips screwdriver, one on the right speaker and two on the left speaker.
Unscrew the three 6mm screws using a #00 Phillips screwdriver, one on the right speaker and two on the left speaker.
Step 7
- Remove each speaker one at a time.
- Carefully remove the wire connecting the two speakers, which is tucked under small plastic hooks on the bottom edge of the device.
Remove each speaker one at a time.
Carefully remove the wire connecting the two speakers, which is tucked under small plastic hooks on the bottom edge of the device.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 4 other contributors
Steven Ngo
Member since: 10/10/2019
835 Reputation
7 Guides authored
Badges:
10
+7 more badges
Team
Cal Poly, Team S12-G2, Regan Fall 2019
Member of Cal Poly, Team S12-G2, Regan Fall 2019
CPSU-REGAN-F19S12G2
4 Members
23 Guides authored
