Difficulty

Easy

Steps

7

Time Required

                          3 minutes

Sections

2

  • Battery
  • 4 steps
  • Hard Drive
  • 3 steps

Flags

1

Needs Better Images

Better photos will improve this guide. Help out by taking, editing, or uploading new ones!

  • BackHP G60-443CL

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

The only tools needed is a Positive PH0 screwdriver.

What you need

Step 1

              Battery
  • Place the laptop upside down where the headphone and auxiliary jack are facing you.

Place the laptop upside down where the headphone and auxiliary jack are facing you.

1024

Step 2

  • In the top left corner, there is a lever that has a small picture of a battery on it. Slide the lever to the left.

In the top left corner, there is a lever that has a small picture of a battery on it. Slide the lever to the left.

Step 3

  • Once you have slid the lever to the left, the front part of the battery will be released and you should be able to grab the released part of the battery with your thumb.

Once you have slid the lever to the left, the front part of the battery will be released and you should be able to grab the released part of the battery with your thumb.

Step 4

  • The battery can then be pulled out of its compartment by hand.

The battery can then be pulled out of its compartment by hand.

Step 5

              Hard Drive
  • Once the battery has been removed, locate the 5mm Phillips #0 screws on the bottom right panel.
  • Remove the 5mm Phillips #0 screws using the Phillips #0 Screwdriver.
  • Next, remove the panel that was attached to the screws, leaving the hard drive exposed.

Once the battery has been removed, locate the 5mm Phillips #0 screws on the bottom right panel.

Remove the 5mm Phillips #0 screws using the Phillips #0 Screwdriver.

Next, remove the panel that was attached to the screws, leaving the hard drive exposed.

Step 6

  • After the panel has been removed, use the screwdriver to remove the three 3mm Phillips #0 screws attached to the hard drive.

After the panel has been removed, use the screwdriver to remove the three 3mm Phillips #0 screws attached to the hard drive.

Step 7

  • Once the screws attached to the hard drive are removed, you will be able to take the hard drive out of the compartment.

Once the screws attached to the hard drive are removed, you will be able to take the hard drive out of the compartment.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 


                    Larissa Moreno-Trejo

Member since: 11/07/2017

101 Reputation

                                      1 Guide authored                  



                       Badges:
                       3

Team

                       Baylor, Team S8-G7, Johnson Fall 2017                        

                                                  Member of Baylor, Team S8-G7, Johnson Fall 2017 



                    BU-JOHNSON-F17S8G7                     


                                            3 Members                     


                                            4 Guides authored