Difficulty

Easy

Steps

5

Time Required

                          5 - 10 minutes

Sections

2

  • Battery
  • 2 steps
  • RAM
  • 3 steps

Flags

0

  • BackHP Mini 1000

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Battery
  • With the case closed, place the Mini 1000 top-side down on a flat surface.
  • Push both of the battery release latches toward each other.

With the case closed, place the Mini 1000 top-side down on a flat surface.

Push both of the battery release latches toward each other.

1024

Step 2

  • Lift the battery out of the Mini 1000 from the edge closest to the release latches.

Lift the battery out of the Mini 1000 from the edge closest to the release latches.

Step 3

              RAM
  • Before proceeding, slide the right battery release latch to the unlocked position nearest the center of the computer.
  • Use the tip of a spudger to slide the RAM compartment cover release latch away from the center of the computer.
  • At this point, the edge of the RAM compartment cover nearest the battery compartment should pop up from the lower case.

Before proceeding, slide the right battery release latch to the unlocked position nearest the center of the computer.

Use the tip of a spudger to slide the RAM compartment cover release latch away from the center of the computer.

At this point, the edge of the RAM compartment cover nearest the battery compartment should pop up from the lower case.

Step 4

  • Remove the RAM compartment cover from the lower case.

Remove the RAM compartment cover from the lower case.

Step 5

  • Use your fingers to simultaneously pull both RAM retaining arms away from the center of the RAM chip.
  • The RAM chip should pop up slightly from its socket.
  • Pull the RAM chip out of its socket and remove it from the Mini 1000.

Use your fingers to simultaneously pull both RAM retaining arms away from the center of the RAM chip.

The RAM chip should pop up slightly from its socket.

Pull the RAM chip out of its socket and remove it from the Mini 1000.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      2 other people completed this guide.

Author

                                      with 4 other contributors 


                    Walter Galan

682,038 Reputation

                                      1,203 Guides authored                  



                       Badges:
                       54







                                                        +51 more badges