Hp Officejet 4650 Power Button Replacement Repair Guide

Difficulty

Moderate

Steps

7

Time Required

                          6 minutes            

Sections

1

• Power Button
• 7 steps

Flags

0

• BackHP OfficeJet 4650

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Power Button               

• Open the cartridge access door by putting one hand on the grooves of each side and pulling up.

Open the cartridge access door by putting one hand on the grooves of each side and pulling up.

1024

Step 2

• Using the 2.0 mm hex screwdriver, remove the 14 mm hex screw that binds the front cover to the printer body by turning the screw counterclockwise.

Using the 2.0 mm hex screwdriver, remove the 14 mm hex screw that binds the front cover to the printer body by turning the screw counterclockwise.

Step 3

• Release the front panel from its internal hooks by applying a little force and sliding the front panel to the right.
• Push the panel upward to remove it from the printer.
• There is a connector attached to the back of the panel. Flip the front cover towards you gently and proceed to the next step.

Release the front panel from its internal hooks by applying a little force and sliding the front panel to the right.

Push the panel upward to remove it from the printer.

There is a connector attached to the back of the panel. Flip the front cover towards you gently and proceed to the next step.

Step 4

• Remove the connector that is attached to the screen’s circuit board by pinching the blue part of the connector with two fingers and pulling it away from the circuit board.

Remove the connector that is attached to the screen’s circuit board by pinching the blue part of the connector with two fingers and pulling it away from the circuit board.

Step 5

• Using the Torx T6 hex screwdriver, remove the 7.0mm screw that binds the front cover to the printer body by turning the screw counterclockwise.

Using the Torx T6 hex screwdriver, remove the 7.0mm screw that binds the front cover to the printer body by turning the screw counterclockwise.

Step 6

• Remove the connector that is attached to the screen’s circuit board by pinching the blue part of the connector with two fingers and pulling it away from button circuit board.

Remove the connector that is attached to the screen’s circuit board by pinching the blue part of the connector with two fingers and pulling it away from button circuit board.

Step 7

• Pop the button off from the black cover by using your finger tip to bring it up.

Pop the button off from the black cover by using your finger tip to bring it up.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 4 other contributors 

                    Stephanie Carpintero                     

Member since: 01/24/2018

970 Reputation

                                      5 Guides authored                  



                       Badges:
                       7







                                                        +4 more badges                           

Team

                       Cal Poly, Team S19-G6, Livingston Winter 2018                        

                                                  Member of Cal Poly, Team S19-G6, Livingston Winter 2018 



                    CPSU-LIVINGSTON-W18S19G6                     


                                            3 Members                     


                                            5 Guides authored                     

cindim - Feb 17, 2020

Reply

Does this fix the printer not turning on?

Mort Rosenberg - Mar 10, 2020

Reply

Where can I purchase the replacement Power Button? What is the part number?