Difficulty

Moderate

Steps

4

Time Required

                          10 minutes            

Sections

1

  • Display
  • 4 steps

Flags

0

  • BackHP Officejet Pro 8620

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Display               
  • Place the printer on its back and rotate the display clockwise to gain access to the underside of the display.

Place the printer on its back and rotate the display clockwise to gain access to the underside of the display.

1024

Step 2

  • Locate the control arm on the underside of the display. You will need to detach this to access the screws.
  • Place a finger behind the control arm.
  • Separate the display unit from the control arm by pulling down with your finger and using your other hand to push the display unit up.
  • Removing the control arm takes a moderate amount of force.

Locate the control arm on the underside of the display. You will need to detach this to access the screws.

Place a finger behind the control arm.

Separate the display unit from the control arm by pulling down with your finger and using your other hand to push the display unit up.

Removing the control arm takes a moderate amount of force.

Step 3

  • Remove the four 11mm T9-Torx screws on the underside of the display unit by rotating the screwdriver counter clockwise.
  • Open the display unit to expose the circuit board by separating the back and front panels.
  • Remove the ribbon cable by gently releasing the plastic locking mechanism and pulling the cable away from the circuit board.

Remove the four 11mm T9-Torx screws on the underside of the display unit by rotating the screwdriver counter clockwise.

Open the display unit to expose the circuit board by separating the back and front panels.

Remove the ribbon cable by gently releasing the plastic locking mechanism and pulling the cable away from the circuit board.

Step 4

  • Remove the four 7mm T9-Torx screws from the circuit board that are holding the screen in place using a T9-Torx screwdriver and turning counter clockwise.
  • Lift the circuit board/screen panel from the black frame.

Remove the four 7mm T9-Torx screws from the circuit board that are holding the screen in place using a T9-Torx screwdriver and turning counter clockwise.

Lift the circuit board/screen panel from the black frame.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      3 other people completed this guide.                                             

Author

                                      with 3 other contributors 

                    Dallas Rocha                     

Member since: 01/24/2018

222 Reputation

                                      1 Guide authored                  



                       Badges:
                       5







                                                        +2 more badges                           

Team

                       Cal Poly, Team S19-G2, Livingston Winter 2018                        

                                                  Member of Cal Poly, Team S19-G2, Livingston Winter 2018 



                    CPSU-LIVINGSTON-W18S19G2                     


                                            3 Members                     


                                            4 Guides authored