Hp Officejet Pro 8620 Power Adapter Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

                          15 minutes

Sections

Left Panel
4 steps
Power Adapter
4 steps

Flags

BackHP Officejet Pro 8620
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Left Panel

Turn off the printer and remove the power cable.
Remove two 13mm T9 screws using a T9-Torx screwdriver. Turn counterclockwise until the screws are released.

Turn off the printer and remove the power cable.

Remove two 13mm T9 screws using a T9-Torx screwdriver. Turn counterclockwise until the screws are released.

1024

Step 2

Open the front door by placing your finger on the indented groove on the left side of the printer and pulling down
This will give you access to the two T9-TORX 13mm screws that need to be removed to release the panel.

Open the front door by placing your finger on the indented groove on the left side of the printer and pulling down

This will give you access to the two T9-TORX 13mm screws that need to be removed to release the panel.

Step 3

Remove the two 13mm screws with a T9-TORX screwdriver by turning counter-clockwise (left).

Remove the two 13mm screws with a T9-TORX screwdriver by turning counter-clockwise (left).

Step 4

Gently remove the left side panel by placing your palm flat against the surface and pulling down.

Gently remove the left side panel by placing your palm flat against the surface and pulling down.

Step 5

              Power Adapter

Remove two screws 13mm screws with a T9-Torx screwdriver by rotating them counterclockwise.

Remove two screws 13mm screws with a T9-Torx screwdriver by rotating them counterclockwise.

Step 6

Unplug the black cable .
Move all the cables and wires to the top of the motherboard to allow the power adapter underneath to be removed freely.

Unplug the black cable .

Move all the cables and wires to the top of the motherboard to allow the power adapter underneath to be removed freely.

Step 7

Gently bend the black ribbon cable.
Remove one 8mm T8 screw underneath the ribbon cable by rotating it counterclockwise with a T8 -Torx screwdriver.
Take out the black plastic cover and the colored wires connected to it.
Now you have cleared a passage for the power adapter to be taken out.

Gently bend the black ribbon cable.

Remove one 8mm T8 screw underneath the ribbon cable by rotating it counterclockwise with a T8 -Torx screwdriver.

Take out the black plastic cover and the colored wires connected to it.

Now you have cleared a passage for the power adapter to be taken out.

Step 8

Gently pulling out the power adapter.
Be careful with all the wires when pulling out the adapter.

Gently pulling out the power adapter.

Be careful with all the wires when pulling out the adapter.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 4 other contributors

                    Scott

Member since: 01/24/2018

509 Reputation

                                      3 Guides authored                  



                       Badges:
                       8







                                                        +5 more badges

Team

                       Cal Poly, Team S19-G2, Livingston Spring 2018                        

                                                  Member of Cal Poly, Team S19-G2, Livingston Spring 2018 



                    CPSU-LIVINGSTON-S18S19G2                     


                                            1 Member                     


                                            3 Guides authored

Introduction#

What you need#

Team#

Introduction

What you need

Team