Hp Officejet Pro 8625 Display Motherboard Replacement Repair Guide

Difficulty

Moderate

Steps

6

Time Required

                          10 - 15 minutes            

Sections

1

• Display Motherboard
• 6 steps

Flags

0

• BackHP Officejet Pro 8625

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Display Motherboard               

• Disconnect the display by holding it in place while pulling down on the plastic hinge.
• Slowly apply more and more force as it does take a lot to separate, do not worry about the hinge or display breaking.

Disconnect the display by holding it in place while pulling down on the plastic hinge.

Slowly apply more and more force as it does take a lot to separate, do not worry about the hinge or display breaking.

1024

Step 2

• Lift the display as high as it will allow to expose the back of the display.
• Pinch the sides of the cover and pull away from the printer to reveal the connector.
• Remove the connector by pulling both away from the display and towards the printer.

Lift the display as high as it will allow to expose the back of the display.

Pinch the sides of the cover and pull away from the printer to reveal the connector.

Remove the connector by pulling both away from the display and towards the printer.

Step 3

• Remove the four 6.2 mm T9 screws from the back of the display.
• Pull the display assembly up and away from the printer.

Remove the four 6.2 mm T9 screws from the back of the display.

Pull the display assembly up and away from the printer.

Step 4

• Remove the back cover from the display assembly by pressing down on the point of connection.
• If you use a plastic spudger for this step, be careful not to brake the plastic as you do not need to use much force to remove the back cover.

Remove the back cover from the display assembly by pressing down on the point of connection.

If you use a plastic spudger for this step, be careful not to brake the plastic as you do not need to use much force to remove the back cover.

Step 5

• Remove the four 4.8 mm T6 screws from the back of the display motherboard.

Remove the four 4.8 mm T6 screws from the back of the display motherboard.

Step 6

• Remove the connection on the front of the display motherboard.
• Remove the display motherboard.

Remove the connection on the front of the display motherboard.

Remove the display motherboard.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors 

                    Daniel                     

Member since: 10/08/2018

277 Reputation

                                      2 Guides authored                  



                       Badges:
                       8







                                                        +5 more badges                           

Team

                       Cal Poly, Team S13-G3, White Fall 2018                        

                                                  Member of Cal Poly, Team S13-G3, White Fall 2018 



                    CPSU-WHITE-F18S13G3                     


                                            3 Members                     


                                            7 Guides authored