Hp Pavilion 11 N010Dx Battery Replacement Repair Guide

Difficulty

Easy

Steps

Time Required

                          5 minutes

Sections

Battery
7 steps

Flags

BackHP Pavilion 11-n010dx
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Battery

Use the nylon spudger to remove the rubber pads near the hinge of the screen, then remove the screws under the pads.
Use the Phillips #0 to remove four 9mm screws.
Use the Phillips #0 to remove seven 6mm screws.

Use the nylon spudger to remove the rubber pads near the hinge of the screen, then remove the screws under the pads.

Use the Phillips #0 to remove four 9mm screws.

Use the Phillips #0 to remove seven 6mm screws.

1024

Step 2

Use the nylon spudger to pry the back casing near the hinges for the screen.
Continue to pry along the edge of the back case until the back is ready to be removed.
Careful when beginning to remove the case. There is a cable attached between the bottom case and the motherboard that must be properly disconnected.

Use the nylon spudger to pry the back casing near the hinges for the screen.

Continue to pry along the edge of the back case until the back is ready to be removed.

Careful when beginning to remove the case. There is a cable attached between the bottom case and the motherboard that must be properly disconnected.

Step 3

Use the blue plastic opening tool to lift up on the white tab that is holding the cable in place on the motherboard.
Now carefully pull the cable out of place and remove the entire back casing.

Use the blue plastic opening tool to lift up on the white tab that is holding the cable in place on the motherboard.

Now carefully pull the cable out of place and remove the entire back casing.

Step 4

Remove the five 6mm screws that hold the battery in place using the Phillips #0.

Remove the five 6mm screws that hold the battery in place using the Phillips #0.

Step 5

Use the nylon spudger to pry away the blue/white wire that is positioned near your battery.

Use the nylon spudger to pry away the blue/white wire that is positioned near your battery.

Step 6

Disconnect the battery cable from the motherboard by carefully pulling on the black wire at the point closest to the white tab.

Disconnect the battery cable from the motherboard by carefully pulling on the black wire at the point closest to the white tab.

Step 7

Remove the battery from your device.

Remove the battery from your device.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      2 other people completed this guide.

Author

                                      with 5 other contributors

                    Joseph Lintz

Member since: 09/15/2016

891 Reputation

                                      5 Guides authored                  



                       Badges:
                       10







                                                        +7 more badges

Team

                       USF Tampa, Team 11-5, Blackwell Fall 2016                        

                                                  Member of USF Tampa, Team 11-5, Blackwell Fall 2016 



                    USFT-BLACKWELL-F16S11G5                     


                                            3 Members                     


                                            5 Guides authored

norman.huntbach - Oct 19, 2018

Only four 6mm screws retaining battery, middle screw secures by passing through back cover. Otherwise very helpful.

premium destroyers - Jun 20, 2020

i followed every step on this guide and when i was finished my laptop wouldn’t turn on

Introduction#

What you need#

Team#

Introduction

What you need

Team