Hp Pavilion 17 E117Dx Wlan Module Replacement Repair Guide

Difficulty

Moderate

Steps

8

Time Required

                          7 - 10 minutes            

Sections

3

• Battery
• 2 steps
• Service Panel
• 3 steps
• WLAN Module
• 3 steps

Flags

0

• BackHP Pavilion 17-e117dx

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

Before attempting to replace the WLAN module, make sure the laptop is powered off and nothing is plugged into the laptop. Also, make sure that the battery is removed.

Your hands must be clean and dry before beginning this procedure.

What you need

Step 1

              Battery               

• Turn the laptop upside down, so that the bottom is facing up.

Turn the laptop upside down, so that the bottom is facing up.

1024

Step 2

• Slide the battery release latch to the left. The battery will pop up slightly.
• Lift the battery upwards and out of the laptop.

Slide the battery release latch to the left. The battery will pop up slightly.

Lift the battery upwards and out of the laptop.

Step 3

              Service Panel               

• Using a Phillips #00 screwdriver, remove the single Phillips 3.0 x 10.5 mm screw that fastens the service panel to the laptop.

Using a Phillips #00 screwdriver, remove the single Phillips 3.0 x 10.5 mm screw that fastens the service panel to the laptop.

Step 4

• Slide the service panel towards you to loosen it from the laptop.

Slide the service panel towards you to loosen it from the laptop.

Step 5

• Remove the service panel.

Remove the service panel.

Step 6

              WLAN Module               

• Remove the two antenna cables from the top of the WLAN module by pulling them upwards.
• Be gentle when removing the cables. You don’t want to damage them.

Remove the two antenna cables from the top of the WLAN module by pulling them upwards.

Be gentle when removing the cables. You don’t want to damage them.

Step 7

• Remove the single Phillips PM 2.5 x 3.25 screw so that you can remove the WLAN module from the system board.
• Use the Phillips #00 screwdriver.

Remove the single Phillips PM 2.5 x 3.25 screw so that you can remove the WLAN module from the system board.

Use the Phillips #00 screwdriver.

Step 8

• To remove the WLAN module, pull it away from the slot at an angle.

To remove the WLAN module, pull it away from the slot at an angle.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor 

                    Marcel Amazan                     

Member since: 03/24/2019

555 Reputation

                                      5 Guides authored                  



                       Badges:
                       9







                                                        +6 more badges                           

Team

                       UMass Dartmouth, Team S8-G5, Bailey Spring 2019                        

                                                  Member of UMass Dartmouth, Team S8-G5, Bailey Spring 2019 



                    UMASSD-BAILEY-S19S8G5                     


                                            2 Members                     


                                            6 Guides authored