Hp Pavilion 17 G119Dx Ram Replacement Repair Guide

Difficulty

Moderate

Steps

12

Time Required

                          10 minutes            

Sections

2

• Battery
• 4 steps
• RAM
• 8 steps

Flags

0

• BackHP Pavilion 17-g119dx

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Battery               

• Close your laptop and turn it over so that the bottom is facing up.

Close your laptop and turn it over so that the bottom is facing up.

1024

Step 2

• In the upper left hand corner, slide the bar with the lock icon to the right. This will unlock the battery.

In the upper left hand corner, slide the bar with the lock icon to the right. This will unlock the battery.

Step 3

• Slide the bar with the battery icon, on the right of your laptop, to the left to release the battery.

Slide the bar with the battery icon, on the right of your laptop, to the left to release the battery.

Step 4

• Grab the battery and remove it from the laptop.

Grab the battery and remove it from the laptop.

Step 5

              RAM               

• Remove the twenty 6.5mm screws using the Phillips #00 screwdriver.
• Two of these 6.5mm screws are covered by a silver sticker. Remove the sticker by gently scraping your finger nail under the sticker and then remove the screws.

Remove the twenty 6.5mm screws using the Phillips #00 screwdriver.

Two of these 6.5mm screws are covered by a silver sticker. Remove the sticker by gently scraping your finger nail under the sticker and then remove the screws.

Step 6

• Remove the black corner covers on either side of the battery to reveal four additional 6.5mm Phillips #00 screws.

Remove the black corner covers on either side of the battery to reveal four additional 6.5mm Phillips #00 screws.

Step 7

• Remove the four 6.5mm Phillips #00 screws that were underneath the black corner covers.

Remove the four 6.5mm Phillips #00 screws that were underneath the black corner covers.

Step 8

• On the right-hand corner of the laptop, remove the CD-ROM by pressing the small button on the side. Pull it out of the laptop, and set it to the side.

On the right-hand corner of the laptop, remove the CD-ROM by pressing the small button on the side. Pull it out of the laptop, and set it to the side.

Step 9

• Make sure that all screws and the CD-ROM Drive are removed before trying to complete this step to prevent damaging your laptop. During this step, you will likely hear loud crackling noises. This is normal.
• Flip the computer back over with the screen facing up and open the laptop.
• Use the Plastic Opening Tool to separate the face plate from the backing.

Make sure that all screws and the CD-ROM Drive are removed before trying to complete this step to prevent damaging your laptop. During this step, you will likely hear loud crackling noises. This is normal.

Flip the computer back over with the screen facing up and open the laptop.

Use the Plastic Opening Tool to separate the face plate from the backing.

Step 10

• After running the Plastic Opening Tool along the sides, you can gently lift the keyboard up and on top of the screen to access the RAM.
• The RAM will be located above the Motherboard and next to the Processor.

After running the Plastic Opening Tool along the sides, you can gently lift the keyboard up and on top of the screen to access the RAM.

The RAM will be located above the Motherboard and next to the Processor.

Step 11

• Release the RAM by pulling the two white levers away from the sides of the RAM.

Release the RAM by pulling the two white levers away from the sides of the RAM.

Step 12

• Pull the RAM up and out of the laptop to remove it.
• When reassembling, be sure to insert the RAM at the same angle it came out. Then push it down into place.

Pull the RAM up and out of the laptop to remove it.

When reassembling, be sure to insert the RAM at the same angle it came out. Then push it down into place.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      3 other people completed this guide.                                             

Author

                                      with 2 other contributors 

                    Morgan Best                     

Member since: 10/30/2017

403 Reputation

                                      2 Guides authored                  



                       Badges:
                       10







                                                        +7 more badges                           

Team

                       University of North Texas, Team S1-G2, Boettger Fall 2017                        

                                                  Member of University of North Texas, Team S1-G2, Boettger Fall 2017 



                    UNT-BOETTGER-F17S1G2                     


                                            2 Members                     


                                            5 Guides authored                     

Andres Toro - Apr 18, 2019

Reply

Ddr3 or ddr4?