Difficulty
Difficult
Steps
9
Time Required
25 - 30 minutes
Sections
2
- Battery
- 3 steps
- Screen
- 6 steps
Flags
1
Better Introduction
Improve this guide by completing or revising its introduction.
BackHP Pavilion 17-g192dx
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Battery
- Turn off the laptop.
- Slide the battery lock to the right until you see the open lock symbol.
Turn off the laptop.
Slide the battery lock to the right until you see the open lock symbol.
1024
Step 2
- Slide the battery release to the left until the battery pops up.
- This may require significant force.
Slide the battery release to the left until the battery pops up.
This may require significant force.
Step 3
- Lift the battery up.
Lift the battery up.
Step 4
Screen
- Using the metal spudger, remove the 2 plastic screw covers at the bottom corners of the screen.
Using the metal spudger, remove the 2 plastic screw covers at the bottom corners of the screen.
Step 5
- Remove the two 7mm screws with a Philips #00 screwdriver.
Remove the two 7mm screws with a Philips #00 screwdriver.
Step 6
- Use a plastic opening tool to remove the plastic cover surrounding the screen by running the tool around the edge.
- It may be helpful to start with the metal spudger then transition to the plastic opening tool because you will need the metal tip get in initially.
Use a plastic opening tool to remove the plastic cover surrounding the screen by running the tool around the edge.
It may be helpful to start with the metal spudger then transition to the plastic opening tool because you will need the metal tip get in initially.
Step 7
- Remove the four 4 mm screws holding the back to the display assembly with a Philips #00 screwdriver.
- Remove the two 3mm screws holding the back cover to the display assembly with a Philips #00 screwdriver.
- Lay the cover on the workspace carefully as not to damage the wires still connected to it.
Remove the four 4 mm screws holding the back to the display assembly with a Philips #00 screwdriver.
Remove the two 3mm screws holding the back cover to the display assembly with a Philips #00 screwdriver.
Lay the cover on the workspace carefully as not to damage the wires still connected to it.
Step 8
- Unplug the wire connected to the display assembly by gently pulling on it.
- Tape may be holding it in place.
Unplug the wire connected to the display assembly by gently pulling on it.
Tape may be holding it in place.
Step 9
- Remove the four 3mm screws connecting the display assembly to the metal framework with a Philips #00 screwdriver.
- It may be helpful to have someone else support the screen while you remove it.
Remove the four 3mm screws connecting the display assembly to the metal framework with a Philips #00 screwdriver.
It may be helpful to have someone else support the screen while you remove it.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
3 other people completed this guide.
Author
with 3 other contributors
Dominic Perito
Member since: 09/20/2019
580 Reputation
5 Guides authored
Badges:
13
+10 more badges
Team
Embry-Riddle Aeronautical University, Team S2-G121, Watkins Fall 2019
Member of Embry-Riddle Aeronautical University, Team S2-G121, Watkins Fall 2019
ERAU-WATKINS-F19S2G121
3 Members
6 Guides authored
